![]() ![]() Īnd by the way I've changed a small thing in the schematic so here is the updated version: After install you should get the following. The board will restart as Arduino Due (you'll need to install the arduino due drivers that comes with the arduino IDE). Then open Arduino IDE and upload the blink sketch. After installing the drivers you should get the following: When you attach the USB the first time, you need the drivers delivered with SAM-BA. After two hours of trying to fit the break out (made wrong measurements) board to my newly soldered board it's finally working.īreakout board attached to the board (Front): It was probably noise from the breadboard. ![]() ![]() To all of you, yes it works now :D:D:D:D. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |